全自動攪拌車的裝料運輸過程中，在您進行操作的時候一定要注意安全，不要出現相關的錯誤操作，當然在任何方面都應該仔細一點。下面來講講怎么安全裝修并安全運輸。

During the loading and transportation process of the fully automatic mixer, you must pay attention to safety when you operate, and do not make relevant mistakes. Of course, you should be careful in all aspects. Now let's talk about how to decorate and transport safely.

裝料中

Loading

裝料前應先將攪拌筒反轉。車輛頭班運行時盡可能先反轉，因大多是露天停放，罐里可能會有積水、樹葉等雜物，如不排出將影響混凝土質量。

The mixing drum shall be reversed before loading. During the first shift operation, the vehicle shall be reversed as far as possible. Because most vehicles are parked in the open air, there may be water, leaves and other debris in the tank. If it is not discharged, the concrete quality will be affected.

裝完料要記得沖洗進料斗，要不然裝料時散落的小石子容易凝固在接料斗內外和溜槽上，影響使用和美觀。

After loading, remember to wash the feed hopper, otherwise the small stones scattered during loading will easily solidify inside and outside the receiving hopper and on the chute, affecting the use and beauty.

運輸中

In transit

拐彎的時候一定要慢，攪拌車重心高，易側翻!入彎之前提前減速減擋，盡量別拐彎的時候踩剎車。隨時通過后視鏡注意觀察罐子是否在轉，把轉速盡量調慢，轉速過高，車輛容易擺動。

When turning, you must be slow. The mixer truck has a high center of gravity and is easy to roll over! Slow down and downshift in advance before turning, and try not to brake when turning. Observe whether the tank is rotating through the rearview mirror at any time, and adjust the speed as slowly as possible. If the speed is too high, the vehicle is easy to swing.

不好的路面低速擋通過，遇到路面不平、坑坑洼洼地方用合適的低速擋通過，保證車子的動力充沛。遇到大坑，石頭，鋼筋，鐵塊盡量避讓?zhuān)绕渲剀?chē)。

If the road surface is not good, use a low gear to pass through uneven and potholed areas, so as to ensure that the car has sufficient power. Avoid big pits, stones, steel bars and iron blocks, especially heavy vehicles.

上坡好是提前減檔，如果拉得滿的話，注意起步要平緩，上坡更要注意，不能亂減擋，好提前減擋。同時，好加快罐子的轉速，已免混凝土流出。

When going uphill, you should downshift ahead of time. If you pull full, you should start slowly. When going uphill, you should pay more attention. You should not downshift randomly, so you can downshift ahead of time. At the same time, it is good to speed up the rotation speed of the tank to prevent concrete from flowing out.

下坡切勿重車空擋滑行，長時間行駛或者下坡前都要掛入合適檔位行駛。切勿重車空擋滑行下坡。下坡拐彎時提前減速然后再減擋再減速，帶擋剎車效果好。

Do not coast with heavy vehicles in neutral gear when going downhill. Drive in proper gear for a long time or before going downhill. Do not slide downhill with loaded vehicles in neutral gear. When going downhill and turning, decelerate in advance, then downshift and decelerate again. The effect of braking in gear is good.

一定要注意限高問題，工地路況復雜，要小心樹木等，特別是要防止刮到電線。

Attention must be paid to the problem of height limit. The road conditions on the construction site are complex, so be careful of trees, especially to prevent scraping the wires.

全自動攪拌車的裝料運輸過程中的正確操作就講解到這里了，為了人員安全以及設備完好著想，您要多去了解多去牢記注意事項。關注我們http://www.yexingrack.com了解更多！

The correct operation of the fully automatic mixer during loading and transportation will be explained here. For the sake of personnel safety and equipment integrity, you should learn more and remember the precautions. Follow us http://www.yexingrack.com Learn more!